Dell EMC Core XC750 - BOSS S2 module

BOSS S2 module
Removing the BOSS S2 module blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
Use a screwdriver to push out the blank from the BOSS S2 module bay.
Figure 150. Removing the BOSS S2 module blank
Removing the BOSS S2 module
The procedure to remove is the BOSS S2 module with 4 x 2.5-inch rear drive module is same.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
Installing and removing system components
139