Figure 132. Removing the Riser 1 blank
Figure 133. Removing the Riser 4 blank
2. To install the full length expansion card risers:
a. Connect the GPU cable to the system board.
b. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
c. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully
seated on the system board connector.
d. Tighten the captive screws on the risers and system if any.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
126 Installing and removing system components
To Next Page
Loading...
