Table 54. GPU power cable matrix (continued)
Category Description Type Vendor Cable Cable quantity
HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length
NOTE: Maximum of two double width GPUs with power cables or a maximum of eight single widh GPUs are supported
in a system.
8. Install the full length expansion card riser or half height expansion card riser. See GPU kit components table for supported
GPU risers.
9. Install the GPU air shroud filler.
10. Install the GPU air shroud top cover.
11. Install the foam on the system cover. To install the foam,
a. Place the system cover with the System Information Lable (SIL) side facing up.
b. For easier handling, peel off a small section of the adhesive cover and align the foam with the system cover.
c. Remove rest of the adhesive cover, and install foam on the system cover.
d. Press along the length of the foam to ensure that it is firmly affixed to the system cover.
Figure 181. Installing Mylar foam on the system cover
After installing, follow the After working inside your system instructions.
168
Upgrade Kits
To Next Page
Loading...
