Table 33 Dispersion kit model numbers, VMAX 950F (continued)
Model Description
ET-DSOPTICE7U VMAX AF ENG 7 DSP CBLOPTICS KIT UPG
ET-DSOPTICE8 VMAX AF ENG 8 DSP CBLOPTICS KIT
ET-DSOPTICE8U VMAX AF ENG 8 DSP CBLOPTICS KIT UPG
Securing kits
VMAX 250F
The Securing Kits contain heavy brackets plus hardware used to attach the brackets
to the frames of the system bay. The brackets are attached to the floor using bolts
that engage the flooring substructure provided by the customer.
The
EMC VMAX Securing Kit Installation Guide
provides installation instructions.
Table 34 Securing kit models, VMAX 250F
Model Description
ES-SECURE Secure kit for single bay
ES-SECUREJK Secure kit for joining bays
VMAX 450F, VMAX 850F, VMAX 950F
The Securing Kits contain heavy brackets plus hardware used to attach the brackets
to the frames of the system bays. The brackets are attached to the floor using bolts
that engage the flooring substructure provided by the customer.
The
EMC VMAX Securing Kit Installation Guide
provides installation instructions.
Table 35
Securing kit models, VMAX 450F, VMAX 850F, VMAX 950F
Model Description
E-SECURE Secure kit for single bay
E-SECUREADD Secure kit for joining bays
GridRunner kit and customer-supplied cable trough
VMAX 250F
The EMC GridRunner
™
bottom routing kit (ES-BOT-KIT) and customer-supplied cable
troughs can help organize and protect subfloor cables.
Each GridRunner supports the cable bundle above the subfloor. GridRunners are
installed with brackets that attach to the stanchions under the raised floor. The
stanchions are up to one inch in diameter, measured at six inches (15.24 cm) below
the raised tiles.
To ensure sufficient support of the cable bundle, a GridRunner should be installed
every two meters.
Optional kits
108 Site Planning Guide VMAX 250F, VMAX 450F, VMAX 850F, VMAX 950F with HYPERMAX OS
To Next Page
Loading...
