Power interface
Data centers must conform to the corresponding specification for arrays installed in
North American, International, and Australian sites.
VMAX 250F
Each system contains a complete set of power distribution equipment.
VMAX 450F, VMAX 850F, VMAX 950F
Each bay in a system configuration contains a complete 2U PDU assembly. The PDU
assembly is constructed with two electrically individual PDUs.
Customers are responsible for meeting all local electrical safety requirements.
Customer input power cabling
Before the array is delivered, the customer must supply and install the required
receptacles on the customer’s PDUs for zone A and zone B power for the system bay.
EMC recommends that the customer's electrician be present at installation time to
work with the EMC Customer Engineer to verify power redundancy.
Refer to the
EMC VMAX Best Practices Guide for AC Power Connections
for required
items at the customer site.
Power cabling, cords and connectors
72 Site Planning Guide VMAX 250F, VMAX 450F, VMAX 850F, VMAX 950F with HYPERMAX OS
To Next Page
Loading...
