Figure 38 Connecting AC power, single-phase
Customer’s PDU 1
Zone B
AC input
cable B
15 ft. extension
cord options
Mating connector or
customer-supplied cable
Customer’s PDU 2
Zone A
AC input
cable A
15 ft. extension
cord options
Mating connector or
customer-supplied cable
EMC-supplied power cable
and connector from the PDU
Cable connectors are shown
as they exit the bottom rear
of the bay.
Rear view
System bay
Zone B PDU
(Left)
Zone A PDU
(Right)
EMC-supplied power cable
and connector from the PDU
P1 P2 P3 P1 P2 P3
P2 and P3 used
depending on
configuration
l
For three-phase power: Connect customer-supplied PDU power cables to
the EMC bay by connecting to the bay's AC input cables for power zone A
and power zone B as shown below.
Best Practices for AC Power Connections
Procedure A, Task 2: EMC Customer Engineer 117
To Next Page
Loading...
