Figure 9: Using Array Handle to Remove the Array
3. Support the weight of the array with one hand underneath it while you use its handle to pull the array out of
the M1000e enclosure. Pull the array out slowly and carefully. When the array enclosure is far enough out of
the chassis, use both hands to support it and remove it from the chassis.
Caution: The array is heavy. Be sure to support it with both hands when you remove it from the M1000e enclo-
sure. After the array is out of the enclosure, place it on a sturdy, flat surface.
17
Dell EqualLogic PS-M4110 Hardware Owner's Manual Removing the Blade Drawer From the Upper Chassis
To Next Page
Loading...
