Dell EqualLogic PS-M4110 Hardware Owner's Manual Chapter 2 Handling the Array
Figure 16: Seating the Array in the Slot
Verify Proper Installation
After you have installed the PS-M4110 into the M1000e chassis, you can verify proper installation by turning
power ON to the M1000e chassis.
• If the PS-M4110 is properly installed, the Blade System Status LED on the unit's front panel will light up
shortly after the M1000e is powered on. See Figure 2 and Table 2 to identify the correct LED.
• If the M1000e is connected to power and turned ON when the PS-M4110 is inserted, the PS-M4110 will
power up as soon as it is fully seated in the M1000e, but the array's Blade System Status front panel LED
may not light up immediately.
24
To Next Page
Loading...
