Dell EqualLogic PS-M4110 - Install the Array in the M1000 e

Dell EqualLogic PS-M4110 Hardware Owner's Manual Chapter 2 Handling the Array
Figure 12: PowerEdge M1000e Chassis
Before installing the PS-M4110 in an M1000e chassis, note:
• You should wear an electrostatic strap to prevent electrostatic damage. See Protecting Hardware on page 6.
• When shipped by itself, the PS-M4110 includes a retaining clip on the front to prevent the array drawer from
sliding out of the array. It also includes protective plastic covers on the back to protect the rear connectors
from damage. You must remove the retaining clip and protective covers before installing the array in the
M1000e chassis. Optionally, you can also remove the protective caps covering the serial ports on the front.
Save the clip and protective covers for future use.
Install the Array in the M1000e
To install the PS-M4110 blade array in an M1000e chassis:
1. Remove the retaining clip from the front of the array and the plastic protective covers from the back of the
array.
2. Lift the PS-M4110 array to align it with either a top or bottom slot in the enclosure, supporting the array with
both hands.
20