Dell EqualLogic PS-M4110 - Default Chapter; Table of Contents

Table of Contents
Preface
vi
1 Getting Started
1
About the PS-M4110 Array
1
Front Panel Features and Indicators
2
Shutting Down and Restarting the Array
4
Protecting Hardware
6
Array Networking Considerations
6
Networking Information Resources
6
Network Requirements
7
Network Recommendations
9
Optional Considerations
10
2 Handling the Array
11
About Handling the Array
11
Opening the Array Drawer
12
Closing the Array Drawer
14
Removing the Array from the M1000e Chassis
15
Removing the Blade Drawer From the Upper Chassis
16
Removing the Array Drawer from a Lower Slot
18
Inserting the Array into the M1000e Chassis
19
Install the Array in the M1000e
20
If installing the array into a top slot in the M1000e chassis
21
If installing the array into a bottom slot in the M1000e chassis
21
Verify Proper Installation
24
Releasing the Array Inner Drawer Safety Latch
25
3 Maintaining Drives
27
About Drives
27
About Mixed-Drive Arrays (Rotational and Solid State)
27
Identifying Failed Drives
27
Interpreting Drive LEDs
28
Array Behavior When a Drive Fails
28
Drive Handling Requirements
29
Replacing Drives
29
Drive Installation Guidelines and Restrictions
29
Removing a Drive
30
Installing a Drive
32
4 Maintaining Control Modules
35
Control Module Description
36
About Control Module Configurations
36
Interpreting Control Module LEDs
37
Identifying Control Module Failures
37
Understanding Failover Behavior
38
Maintaining Control Module Firmware
38
Control Module Handling Requirements
39
Replacing a Control Module
39
Control Module Replacement Procedures
40
Removing a Control Module
41
Installing a Control Module
44
Replacing the microSD Card
46
microSD Card Replacement Procedure
46
Removing the microSD Card
47
iv