PS6500 Hardware Maintenance Maintaining Power Supply and Cooling Modules
4-6
In addition, use the cable management system to organize your power cables. See Using the Cable Management
System on page 1-10 for more information.
Note: If you detached one side of the cable management system from the rear chassis flange for better access, re-
attach it.
If the array was shut down, turn on power to the array. See Turning on Power to an Array on page 1-13.
Make sure the new module is operational. See Power Supply and Cooling Module Status on page 4-2.
Caution: After installing a power supply and cooling module, wait until the new module initializes before
removing the other module. Once connected to a source of power, module initialization generally
completes in one to ten seconds. Initialization is complete when the LCD panel (located behind the
bezel) no longer shows the module failure.
To Next Page
Loading...
