Installing the Software 37
2
Installing the Software
Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode. You must move linearly
through the command modes, with the exception of the end command which
takes you directly to EXEC Privilege mode; the exit command moves you up
one command mode level.
Console Access
RPM Ports and Cables
There are three ports on the RPM: the Console port, the Auxiliary port, and the
10/100 Ethernet port. This chapter includes information to connect to the system
using the console port. For information about connecting with the other ports,
refer to your system's Installation Guide.
Connecting the Console
NOTE: Before starting this procedure, be sure you have a terminal emulation
program already installed on your PC.
Step Task
1
Install an RJ-45 copper cable into the console port. Use a rollover cable
to connect the S4810 console port to a terminal server.
2
Connect the other end of the cable to the DTE terminal server.
To Next Page
Loading...
