44 Installing the Software
Assign an IP Address to a VLAN
NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command.
Connecting the Chassis to the Network
Once you have completed the hardware installation and software configuration,
you can connect to your company network by following your company’s cabling
requirements.
Task Command Syntax Command Mode
Configure an IP address and mask on
the interface.
ip address ip-address
mask [secondary]
INTERFACE
To Next Page
Loading...
