Installing the Software 41
Configure the Management Port IP Address
Assign IP addresses to the management ports in order to access the system
remotely.
NOTE: Assign different IP addresses to each RPM’s management port.
Configure a Management Route
Define a path from the system to the network from which you are accessing the
system remotely. Management routes are separate from IP routes and are only
used to manage the system through the management port.
Configure a Username and Password
Configure a system username and password to access the system remotely.
Step Task Command Syntax Command Mode
1 Enter INTERFACE mode for the
Management port.
interface
ManagementEthernet
slot/port
CONFIGURATION
2 Assign an IPv4 or IPv6 address
to the interface.
ip address {ipv4-
address | ipv6-
address}/mask
INTERFACE
3 Enable the interface. no shutdown INTERFACE
Task Command Syntax Command Mode
Configure an IPv4 or
IPv6 management
route to the network
from which you are
accessing the system.
management route {ipv4-address | ipv6-
address}/mask gateway
CONFIGURATION
To Next Page
Loading...
