Dell Force10 Software Defined Networking User Manual

features-reply Enable debugging for features-reply
packets.
flow-mod Enable debugging for flow-mod packets.
flow-removed Enable debugging for flow-removed
packets.
get-config-reply Enable debugging for get-config-reply
packets.
get-config-
request
Enable debugging for get-config-request
packets.
hello Enable debugging for hello packets.
packet-in Enable debugging for packet-in packets.
packet-out Enable debugging for packet-out packets.
port-mod Enable debugging for port-mod packets.
port-status Enable debugging for port-status packets.
queue-get-
config-reply
Enable debugging for queue-get-config-
reply packets.
queue-get-
config-request
Enable debugging for queue-get-config-
request packets.
set-config Enable debugging for set-config packets.
stats-reply Enable debugging for stats-reply packets.
stats-request Enable debugging for stats-request packets.
vendor Enable debugging for vendor packets.
of-instance { of-id } Enter the keyword of-instance followed by the OF instance ID.
Defaults None
Command Modes EXEC
Command History
Version 9.1(0.0) Introduced on Z9000 and S4810.
Usage
Information
If debugging needs to be enabled for all packets, use the debug openflow packets
packet-type all command.
Related
Commands
reload conditional nvram-cfg-change
29

Dell Force10 Software Defined Networking Specifications

General

Product Type	Switch
Category	Software Defined Networking
Compatibility	OpenFlow
Port Density	Varies by model
Forwarding Capacity	Varies by model
Latency	Varies by model
Power Consumption	Varies by model
Product Family	Force10

Summary

OpenFlow 1.0 Support

Exceptions

ACL Flow Exceptions

Describes exceptions and limitations specific to ACL flows.

L3 Flow Exceptions

Details exceptions and limitations for L3 flows.

L2 Flow Exceptions

Outlines exceptions and limitations for L2 flows.

Learning Bridge (LB) Flow Exceptions

Specifies exceptions and limitations for Learning Bridge (LB) flows.

Flow Setup

ACL Flows

Explains how to set up and view ACL flows with examples.

L3 Flows

Details the configuration for setting up L3 flows with examples.

L2 Flows

Guides on configuring L2 flows on OF VLANs with examples.

Learning Bridge (LB) Flows

Covers the setup and examples for Learning Bridge (LB) flows.

Configuring ACL CAM Carving on S4810

Configuring ACL CAM Carving on Z9000

OpenFlow Instances

OpenFlow Interfaces

OF Ports

OF VLANS

SDN Commands

controller

openflow of-instance

Creates or modifies an OpenFlow instance.

shutdown (OpenFlow Instance)