Dell Force10 Software Defined Networking

Flow Type Maximum Number of Available Flows
L2 48,000
LB 24,000
L3 6,000
• If the time or date on the system clock is changed, you must disable and re-enable all
existing OpenFlow instances to avoid session timeout issues.
Related
Commands
shutdown — Enable or disable the OpenFlow instance.
show openflow — Display general information about OpenFlow instances.
controller — Specify the OpenFlow controller configuration that the OpenFlow instance uses to
establish a connection.
show openflow
Display general information about OpenFlow instances.
Z-Series, S4810
Syntax
show openflow [of-instance[of-id]]
Parameter
of-instance of-id (OPTIONAL)
Enter the keyword of-instance to display information such as
administrative state, interface-type, and operational state for all
OpenFlow instances.
(OPTIONAL) Enter the keyword of-instance followed by the OF
instance ID to display details for the specified OF instance. Range is 1
to 8.
Defaults None
Command Modes EXEC
Command History
Version 9.1(0.0) Introduced on Z9000 and S4810.
Example
FTOS#show openflow of-instance 1
Instance : 1
Admin State : Down
Interface Type : Port
DP Id : 00:01:00:01:e8:8b:1a:30
Forwarding Tbls : acl
Flow map :
LB assist : disabled
EchoReq interval: 15 seconds
Connect interval: 15 seconds
Number of Flows : 0
Packets (acl) : -
Bytes (acl) : -
Controller 1 : TCP, 10.11.205.184/6633, not-connected
Controller 2 : -
Port List :
34