Dell Force10 Software Defined Networking User Manual

flow-map
Specify if flows installed by the controller should be interpreted by the switch for placement in L2 or L3 tables.
Z-Series, S4810
Syntax
flow-map {l2|l3} enable
Parameter
l2 Enter l2 to interpret Layer 2 flows.
l3 Enter l3 to interpret Layer 3 flows.
Defaults None (not enabled)
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0) Introduced on Z9000 and S4810.
Usage
Information
L2 flow-mapping is not supported on OpenFlow instances with an interface-type of “port.”
Related
Commands
openflow of-instance Create or modify an OpenFlow instance.
interface-type
Specify the type of interface (port, VLAN, or any) for the OpenFlow instance.
Z-Series, S4810
Syntax
interface-type {any|port|vlan}
Defaults
port
Parameter
any Enter the keyword any to enable configuration of physical interfaces,
LAGs, and VLANs on the selected OF instance.
port Default. Enter the keyword port to enable configuration of LAGs or
physical interfaces on the selected OF instance.
vlan Enter the keyword vlan to enable configuration of VLANs on the
selected OF instance.
NOTE: You must associate the OF instance with the VLAN when
the VLAN is created.
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0) Introduced on Z9000 and S4810.
30

Dell Force10 Software Defined Networking Specifications

General

Product Type	Switch
Category	Software Defined Networking
Compatibility	OpenFlow
Port Density	Varies by model
Forwarding Capacity	Varies by model
Latency	Varies by model
Power Consumption	Varies by model
Product Family	Force10