Dell Force10 Software Defined Networking User Manual

• GVRP
• IPv4
• IPv6
• MAC
• MTU
• Spanning-tree protocols
• Switchport
Related
Commands
openflow of-instance Create or modify an OpenFlow instance.
openflow of-instance
Create an OpenFlow (OF) instance or modify an existing OpenFlow instance.
Z-Series, S4810
Syntax
openflow of-instance of-id
Parameters
of-id Enter the number of the OF instance. Range is 1 to 8.
If you are creating a new OF instance, enter the number you want to assign to the OF instance.
If you are modifying an existing OF instance, enter the number of the instance you want to
change.
NOTE: You must disable the OF instance before making any configuration changes.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.1(0.0) Introduced on Z9000 and S4810.
Usage
Information
• Stacking for S4810, controller High Availability, and VLT are not supported on OF
instances.
• To enable OpenFlow on S4810, the stack unit number must be zero.
• Up to eight OF instances can be created.
• To establish a connection with the controller, you must enable the OF instance using
the no shutdown command.
• To modify the OF instance, you must disable the OF instance first using the shutdown
command.
• One controller IP and one TCP port can be configured for each OF instance.
• The number of supported flows depends on the flow type. The following table provides
the number of supported flows for each flow type:
Flow Type
Maximum Number of Available Flows
ACL 256 or 512 (depending on ACL CAM carving)
33

Dell Force10 Software Defined Networking Specifications

General

Product Type	Switch
Category	Software Defined Networking
Compatibility	OpenFlow
Port Density	Varies by model
Forwarding Capacity	Varies by model
Latency	Varies by model
Power Consumption	Varies by model
Product Family	Force10