About this task
The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.
Figure 22. Installing the battery
Steps
1. Place the battery on the palm-rest and keyoard assembly.
2. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the four screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to its connector on the system board.
5. Adhere the tape that secures the battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Battery cable
Removing the battery cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
50
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
