NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
Figure 23. Removing the battery cable
Steps
1. Remove the battery cable from the routing guides on the battery.
2. Slide down the clamp that secures the battery cable to the battery.
3. Disconnect and remove the battery cable from the battery.
4. Lift the battery cable off the battery.
Installing the battery cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery cable and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
51
To Next Page
Loading...
