Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Speaker and antenna assembly
NOTE: The antenna cables are attached to the speakers as an assembly and cannot be replaced separately.
Removing the speaker and antenna assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the wireless card.
About this task
NOTE:
The wireless antennas are attached to the speakers as an assembly and cannot be separated for individual
replacement. When the speakers or the wireless antennas need to be replaced, services will dispatch the speaker and
antenna assembly as a single serviceable component.
The following image(s) indicate the location of the speaker and antenna assembly and provides a visual representation of the
removal procedure.
58
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
