Figure 26. Display assembly
Steps
1. Lift the latch and disconnect the display-assembly cable from its connector on the system board.
2. Remove the two screws (M2.5x5) that secure the left display-assembly hinge to the system board.
3. Pry open the left display-assembly hinge at a 90-degree angle.
4. Peel the tape that secures the display-assembly cable ot its latch on the system board.
5. Remove the two screws (M2.5x5) that secure the right display-assembly hinge to the system board.
6. Pry open the right display-assembly hinge at a 90-degree angle.
7. Lift the palm-rest and keyboard assembly at an angle off the display assembly.
Installing the display assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the installation
procedure.
54
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
