Figure 27. Installing the display assembly
Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Align and place the palm-rest and keyboard assembly under the display hinges.
3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the palm-rest and
keyboard assembly.
4. Replace the two screws (M2.5x5) that secure the left display-assembly hinge to the palm-rest and keyboard assembly.
5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the palm-rest and
keyboard assembly.
6. Replace the two screws (M2.5x5) that secure the right display-assembly hinge to the palm-rest and keyboard assembly.
Removing and installing Field Replaceable Units (FRUs)
55
To Next Page
Loading...
