About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Figure 34. Removing the power-adapter port
Steps
1. Remove the two screws (M2.5x5) that secure the left display-assembly hinge to the system board.
2. Pry open the left display-assembly hinge at a 90-degree angle.
3. Peel the tape that secures the power-adapter port cable to its connector on the system board.
4. Disconnect the power-adapter port cable from its connector on the system board.
5. Remove the power-adapter port cable from the routing guide on the palm-rest and keyboard assembly.
6. Lift the power-adapter port off the palm-rest and keyboard assembly.
Installing the power-adapter port
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the installation
procedure.
64
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
