Figure 30. Removing the speaker and antenna assembly
Steps
1. Disconnect the speaker cable from its connector on the system board.
2. Lift the latch and disconnect the keyboard cable from its connector on the system board.
3. Move the keyboard cable off the speaker and antenna cables.
4. Lift the latch and disconnect the keyboard-backlight cable from its connector on the system board.
5. Move the keyboard-backlight cable off from the speaker and antenna cables.
6. Remove the speaker and the antenna cables from the routing guides on the palm-rest and keyboard assembly.
7. Lift the speaker and antenna assembly off the palm-rest and keyboard assembly.
NOTE: The antenna and cables are a part of the speaker and antenna assembly.
Installing the speaker and antenna assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs) 59
To Next Page
Loading...
