Figure 24. Installing the battery cable
Steps
1. Route the battery cable through the routing guides on the battery.
2. Connect the battery cable to its connector on the battery.
3. Slide the clamp upwards to secure the battery cable to the battery.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your
computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
52
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
