Figure 47. Removing the touchpad
Steps
1. Pry open the touchpad cable connector latch and disconnect the touchpad cable from the touchpad cable connector on the
system board.
2. Pry open the touchpad cable connector latch and disconnect the touchpad cable from the touchpad cable connector on the
touchpad.
3. Lift the touchpad cable off the system board.
4. Remove the four screws (M2x1.8) and the five screws (M2x2.5) that secure the touchpad bracket to the palm-rest and
keyboard assembly.
5. Peel back the tape on the upper right edge of the touchpad bracket.
6. Lift the touchpad bracket off the palm-rest and keyboard assembly.
7. Lift the touchpad off the palm-rest and keyboard assembly.
Installing the touchpad
Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs) 81
To Next Page
Loading...
