7. Connect the display-assembly cable to its connector on the system board and close the latch.
8. Adhere the tape that secures the display-assembly cable to its latch on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your
computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the removal procedure.
Figure 28. Removing the IO board
56
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
