Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: The wireless antennas are attached to the speakers as an assembly and cannot be separated for individual
replacement. When the speakers or the wireless antennas need to be replaced, services will dispatch both the speaker
and antenna assembly as a single serviceable component.
The following image(s) indicate the location of the speaker and antenna assembly and provides a visual representation of the
installation procedure.
Figure 31. Installing the speaker and antenna assembly
Steps
1. Using the alignment posts, place the left speaker and the right speaker on the palm-rest and keyboard assembly.
NOTE: Ensure that the four rubber grommets are seated into the slot and installed correctly on the speakers.
2. Route the speaker and antenna assembly cables through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to its connector on the system board.
4. Connect the keyboard cable to its connector on the system board.
60
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
