Figure 40. Image: Removing the USB board
Steps
1. Remove the two (M2.5x5) screws that secure the left display-assembly hinge on the palm-rest and keyboard assembly.
2. Pry open the left display-assembly hinge at a 90-degree angle.
3. Lift the latch and disconnect the fingerprint-reader cable from its connector on the USB board.
NOTE:
This step is only applicable for computers that are shipped with the power button with an optional fingerprint
reader.
4. Remove the screw (M2x3) that secures the USB board to the palm-rest and keyboard assembly.
5. Lift the USB board from the palm-rest and keyboard assembly and flip it over by folding the USB-board cable gently.
72
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
