About this task
NOTE: You may install either a M.2 2230 or 2280 solid-state drive into the M.2 solid-state drive slot on the system board.
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Figure 19. Installing the solid-state drive
Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card slot.
2. Slide the solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3.5) that secures the solid-state drive to the system board.
4. Place the computer in an upright position.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
41
To Next Page
Loading...
