About this task
NOTE: Depending on the configuration ordered, your computer may have a M.2 2230 or 2280 solid-state drive that is
installed in the M.2 solid-state drive slot on the system board.
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Figure 18. Removing the solid-state drive
Steps
1. Place the computer on its side with the left side facing up.
2. Remove the screw (M2x3.5) that secures the solid-state drive to the system board.
3. Slide and lift the solid-state drive from the M.2 card slot on the system board.
Installing the solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
40
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
