Steps
1. Place the computer on its side with the left side facing up.
2. Disconnect the graphics-card power cable from the graphics card.
3. Press the securing clip and disconnect the processor-power cable from the system board.
4. Press the securing clip and disconnect the system-board power cable from the system board.
5. Remove the power-supply unit cables from the routing guides on the chassis.
6. Remove the three screws (#6-32) that secure the power-supply unit to the chassis.
7. Slide and lift the power-supply unit off the chassis.
Installing the power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the power-supply unit and provides a visual representation of the installation
procedure.
Removing and installing Customer Replaceable Units (CRUs) 61
To Next Page
Loading...
