Figure 38. Removing the antenna modules
Steps
1. Loosen the two captive screws (M3) that secure the antenna modules to the chassis.
2. Remove the antenna cables through the routing guide on the chassis and unroute the antenna cables through the slot on the
chassis.
3. Lift the antenna module along with its cables off the chassis.
Installing the antenna modules
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing Field Replaceable Units (FRUs)
65
To Next Page
Loading...
