Table 22. Antenna-cable color scheme(continued)
Connectors on the
wireless card
Antenna-cable color Silkscreen marking
Auxiliary Black AUX ▲ (black triangle)
2. Slide and place the wireless-card bracket on the wireless card.
3. Align the notch on the wireless card with the tab on the wireless-card slot.
4. Slide the wireless card at an angle into the wireless-card slot.
5. Replace the screw (M2x4) that secures the wireless card to the system board.
6. Place the computer in an upright position.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Coin-cell battery
Graphics card
Removing the graphics card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
NOTE: Depending on the configuration ordered, your computer may not have a discrete graphics card installed.
The following image indicates the location of the graphics card and provides a visual representation of the removal procedure.
44
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
