Figure 46. Removing the system board
5. Lift the system board at an angle and remove it from the chassis.
Installing the system board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the slots and connectors on your system board.
1. processor-power cable connector
2. Processor socket
3. processor-fan cable connector
4. memory-module slots
5. system-board power cable connector
6. coin-cell battery socket
7. power-button cable connector
8. media-card reader cable connector
9. Hard drive power cable connector
10. optical-drive data cable connector (SATA 3)
11. M.2 2230 wireless-card slot
74
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
