Figure 30. Removing the optical-drive bezel
Steps
1. Insert an unfolded paperclip into the emergency eject pinhole of the optical drive to open the drive tray.
2. Using a plastic scribe press down the tab that secures the optical-drive bezel to the optical drive.
3. Lift the optical-drive bezel away from the optical drive.
Installing the optical-drive bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the optical-drive bezel and provides a visual representation of the installation
procedure.
54
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
