Next steps
1. Install the front cover.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the hard drive.
About this task
The following image indicates the location of the power button and provides a visual representation of the removal procedure.
Figure 26. Removing the power button
Steps
1. Disconnect the power-button cable from the system board.
2. Press the release tab on the power button to release it from the slot on the chassis.
3. Route the power button along with its cable through the slot on the chassis.
4. Remove the power button and its cable from the front of the chassis.
Removing and installing Customer Replaceable Units (CRUs)
49
To Next Page
Loading...
