2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the hard drive.
About this task
The following image indicates the location of the media-card reader and provides a visual representation of the removal
procedure.
Figure 34. Removing the media-card reader
Steps
1. Remove the screw (6-32) that secures the media-card reader bracket to the chassis.
2. Using the screw and the screwdriver push against the media-card reader to release it from the chassis.
3. Slide and lift the media-card reader and its bracket off the system board.
Installing the media-card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
58
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
