About this task
The following image indicates the location of the media-card reader and provides a visual representation of the installation
procedure.
Figure 35. Installing the media-card reader
Steps
1. Place and slide the media-card reader onto its slot on the system board.
2. Align the screw hole on the media-card reader bracket with the screw hole on the chassis.
3. Replace the screw (6-32) that secures the media-card reader bracket to the chassis.
Next steps
1. Install the hard drive.
2. Install the front cover.
3. Install the left-side cover.
4. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
59
To Next Page
Loading...
