Figure 45. Removing the screws and Disconnecting the cables
Steps
1. Remove the two screws (6-32) that secure the front I/O-bracket to the chassis.
2. Remove and lift the front I/O-bracket from the chassis.
3. Disconnect all the cables that are connected to the system board.
● processor-power cable
● system-board power cable
● optical-drive data cable
● optical-drive power cable
4. Remove the eight screws (6-32) that secure the system board to the chassis.
Removing and installing Field Replaceable Units (FRUs)
73
To Next Page
Loading...
