About this task
The following image indicates the location of the antenna modules and provides a visual representation of the installation
procedure.
Figure 39. Installing the antenna modules
Steps
1. Place the antenna modules on the chassis.
2. Align the captive screws on the antenna modules with the screw holes on the chassis.
3. Tighten the two captive screws (M3) that secure the antenna modules to the chassis.
4. Route the antenna cables through the slot on the chassis and route the antenna cables through the routing guides on the
chassis.
Next steps
1. Install the wireless card.
2. Install the front cover.
3. Install the left-side cover.
4. Follow the procedure in After working inside your computer.
66
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
