Dell Inspiron 3030 - Page 62

Figure 37. Installing the power-supply unit
Steps
1. Place and slide the tabs on the power-supply unit into the latches on the chassis.
2. Align the screw holes on the power-supply unit to the screw holes on the chassis.
3. Replace the three screws (#6-32) that secure the power-supply unit to the chassis.
4. Route the power-supply unit cables through the routing guides on the chassis.
5. Connect the system-board power cable to the system board.
6. Connect the processor-power cable to the system board.
7. Connect the graphics-card power cable to the graphics card.
8. Place the computer in an upright position.
62
Removing and installing Customer Replaceable Units (CRUs)