Table 26. System setup options—Integrated Devices menu(continued)
Integrated Devices
By default, Enable USB Boot Support is selected.
Front USB Configuration Enables or disables individual USB ports.
By default, Front Port 1 (Bottom Left)* is selected.
By default, Front Port 2 (Bottom Right)* is selected.
By default, Front Port 3 (Top Left) is selected.
By default, Front Port 5 (Top Right) is selected.
* Denotes a USB 3.0-capable port
NOTE: USB keyboard and mouse always work in the BIOS setup
irrespective of this setting.
Rear USB Configuration Enables or disables individual USB ports.
By default, Rear Port 1 (Top Left)* is selected.
By default, Rear Port 2 (Top Right)* is selected.
By default, Rear Port 3 (Bottom Left) is selected.
By default, Rear Port 5 (Bottom Right) is selected.
* Denotes a USB 3.0-capable port
NOTE: USB keyboard and mouse always work in the BIOS setup
irrespective of this setting.
Table 27. System setup options—Storage menu
Storage
SATA Operation
SATA Operation Configures the operating mode of the integrated storage device controller.
Default: RAID On. The storage device is configured to support RAID. (Intel®
Rapid Restore Technology)
Storage Interface
Port Enablement Enables or disables the onboard drives.
Default: SATA-0 is ON
Default: SATA-1 is ON
Default: SATA-3 is ON
Default: M.2 PCIe SDD-0 is ON
SMART Reporting Enable or disable SMART Reporting during system startup.
Default: OFF
Drive Information Displays the information of various onboard drives.
Enable MediaCard Turn on or off all media cards, or enable or disable the media card in read-only
state.
By default, Secure Digital (SD) Card is selected.
Table 28. System setup options—Display menu
Display
Primary Display
BIOS Setup 83
To Next Page
Loading...
