The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
1. Connect the display cable on the connector on the display panel.
2. Affix the rubber sticker on the display cable connector.
3. Affix the mylar tape to secure the display cable on the rear of the display panel.
4. Align the display panel with the display assembly. Gently snap the display bezel into place.
5. Replace the four screws (M2x2.5) to secure the display panel on the display assembly.
6. Gently flip over the display panel.
1. Install the display bezel for laptops, or the touch-panel assembly for 2-in-1s.
2. Install the display assembly for laptops, or the display assembly for 2-in-1s.
3. Install the palmrest and keyboard assembly.
Removing and installing components
71
To Next Page
Loading...
