Steps
1. Insert the hard-drive assembly into the slot on the computer until it clicks into place.
2. For 2.5-inch. hard-disk drive set as primary, connect the power cable and the blue hard-drive data cable to the connectors on the 2.5-
inch hard-disk drive.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
3.5 in. hard-drive assembly
Removing the 3.5-inch hard-disk drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
28
Disassembly and reassembly
To Next Page
Loading...
