Dell OptiPlex 7080 Tower - Installing the 3.5-Inch Hard-Disk Drive Bracket

About this task
The following images indicate the location of the 3.5-inch hard-disk drive bracket and provides a visual representation of the removal
procedure.
Steps
1. Pry one side of the hard-disk drive bracket edge to release the tabs on the bracket from the slots on the hard-disk drive.
2. Lift and remove the hard-disk drive off the hard-disk drive bracket.
Installing the 3.5-inch hard-disk drive bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard-disk drive bracket and provides a visual representation of the installation
procedure.
30
Disassembly and reassembly