Figure 17. Removing the speaker
Steps
1. Disconnect the speaker cable from its connector (INT SPKR) on the system board.
2. Remove the speaker cable from the routing guides on the fan assembly.
3. Press the tab that secures the speaker to the speaker-support bracket.
4. Lift the speaker off the bracket.
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the speaker and provides a visual representation of the installation procedure.
40
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
