Figure 50. Removing the antenna module (white cable)
Steps
1. Remove the antenna cable from the routing guides on the chassis and system board.
2. Remove the screw (M3x3) that secures the antenna module (white cable) to the chassis.
3. Listen the captive screw that secures the antenna module (white cable) to the chassis.
4. Push the antenna module (white cable) through its slot on the back panel of the chassis.
5. Lift the antenna module (white cable) away from the back panel.
Installing the antenna module (white cable)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the antenna module (white cable) and provides a visual representation of the
installation procedure.
74
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
