Removing and installing Field Replaceable
Units (FRUs)
The replaceable components in this chapter are Field Replaceable Units (FRUs).
CAUTION: The information in this removing and installing FRU's section is intended for authorized service
technicians only.
CAUTION: To avoid any potential damage to the component or loss of data, ensure that an authorized service
technician replaces the Field Replaceable Units (FRUs).
CAUTION: Dell Technologies recommends that this set of repairs, if needed, to be conducted by trained
technical repair specialists.
CAUTION: As a reminder, your warranty does not cover damages that may occur during FRU repairs that are not
authorized by Dell Technologies.
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Optional I/O module (HDMI/VGA/DP/Serial/PS2)
Removing the optional I/O module (HDMI/VGA/DP/Serial/PS2)
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
NOTE:
The optional PS2 module comes with a custom Dell adapter cable that is required to access the PS2 I/O port. Plug
in the adapter cable to access the PS2 I/O or COM port of your computer.
The following images indicate the location of the optional I/O module and provide a visual representation of the removal
procedure.
8
58 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
